Speaker Stand
An improvement to the previous stand that was built. It doesn’t have continuous stage, but variable stages. Allowing for quick swappable to a known height.
In association with
Renders
These renders help us to visualised what final material would be ideal for the finishing if we are ever to take this to production.
Previous Design
Inspiration
Ideation
Instead of 2 pins, which would cause the whole top to rotate when one other pin is out. Is a pin and track. Therefore, is not a friction fit, but rather a pin fit, on a track.
Process
I was told to make the version of 2 pin first, as it is easier to drill holes than to make a track. Plus, tracks wear faster overtime.
Problem
During this project, I was very tunnel vision in a specific problem that shouldn’t have been there at the first place. I talked about that here.
Couple of versions
